About IDI Contact Us

TASQtm Line Air Driven Liquid Pumps
•  Durable and affordable alternative for less complicated pressure requirements
•  Complete Unit ready to run
•  No assembly required. Unit arrives built to your specifications, tested and ready for installation
•  Reduced operating cost
•  No energy consumption to maintain position or pressure
•  Lower maintenance cost
•  No heat build up
•  Explosion proof operation

•  Single acting operation
•  Air to Hydraulic ratios available from 5:1 to 60:1 for pressure up to 5000 psi (340 bar)
•  All ratios come standard with a NFPA DO3 (CETOP 3) pad that can be used to mount a directional control valve or can be blocked if not required
•  TASQ Line pumps are compact: 4"x4"x9" w/o reservoir (100x100x228 mm) and lightweight: 11 lb. (5 kg)
•  Polymeric Dynamic Seals and Bearings Standard
•  Easily mounts on your existing reservoir or can be equipped with an optional 40 - 160 cu. in. (.65 - 2.61L) self contained reservoir

•  TASQ Series Product Manual (.pdf)
•  TASQ Series Performance Chart (.pdf)
•  TASQ Series Dimensions (.pdf)
•  TASQ Series Brochure (.pdf)
   
  More Documentation >>

A durable, air driven liquid pump for intermittent flow and pressures with significantly longer service life.
Specifications:
•  Aircraft Grade Aluminum Housing
•  Twin PTFE Seals on Hard Chrome Piston Rod
•  DO3 Valve Pad with 1/4 NPT A, B & GA Ports
•  200 Mesh Suction Strainer
•  Twin 3/8 NPT Air Ports for Supply and/or Gage
•  Compatible with Most Hydraulic Oils
•  Requires Clean, Dry Regulated Air (150 psi max.)(10 bar)
•  No Lubricator Required
TASQ Line air driven liquid pump

The TASQ Line air driven liquid pumps are a single ratio, single acting air driven liquid pump. All ratios are rated at 0.60 peak hydraulic horsepower at a maximum air consumption of 9 SCFM.

TASQ air driven liquid pumps are furnished with either an integral, self-contained reservoir having a capacity of 40, 60, 80 or 120 cubic inch oil capacity or without a reservoir (the non reservoir version includes mounting brackets, pump-to-reservoir gasket and a 200 mesh low profile suction strainer). Reservoirs can be installed so that the two supplied site gages can be viewed from any side. Standard air driven liquid pump installation has site gages facing the regulator side of the pump as shown in the General Arrangement Drawing in the product manual to the right.

To View More Air Driven Liquid Pumps / Air Driven Pumps Click Here.

For more information on the air driven liquid pump seen above please click here or call Toll Free: (800) 539-0193

Home | Products | Applications | Documentation | Distributors | About IDI | Gallery | Contact Us | Distributors Only
© Interface Devices, Inc.
230 Depot Road  •  Milford, CT 06460
Voice: (203) 878-4648  •  Toll Free: (800) 539-0193  •  Fax: (203) 882-0885
info@interfacedevices.com